Gas forge VKP 5

8005

1 138€ tax incl.

925€ tax excl.

More info
A two -burner forge for medium and large blacksmith workshops. Ideal for heating a large amount of charge, especially in mass production. The gas consumption is very low comparing the size of the chamber. It can vary from 1 kg to 2 kg per hour depending on use one or two burners (you can control the burners autonomously). The operating temperature is 1250 ºC. 
The forge is equipped with standard type of burners PB 1 V designed for LPG. It is possible to use ZP-N burners (designed to run on natural gas and compressed air) instead of PB 1 V burners.
The working chamber of the forge is made of refractory concrete. In front, there is a standard hatch with a lifting handle. The hatch is lined with refractory wool, which reduces heat loss during working. The hatch can be attached at different heights, depending on the size of the charge.
In front of the chamber there is also a thermally insulated shelf for heating up long items. At the back of the forge there is a strangler lined with refractory wool, which can be easly dismantled. Then, the forge can work as a continuous furnace.
Technical data

Check the table for more details.

Type of forge

VKP5

 Type of burner / type of gas

2 x PB1V / propane, propane butane
2 x ZP1N / natural gas and compressed air

 Gas consumption/ type of burner

PB1V – 0,70-1,0[kg/h] (x2)
ZP1N - 1,26[m3/h] (x2)

 Flame temperature

1450 [°C]

 Operating temperature

1250 [°C]

 Chamber dimensions

380 x 350 x 120 [mm]

 The front shelf dimensions

480 x 140 [mm]

 Total dimensions

 480 x 600 x 250 [mm]

 Weight

38 [kg]

 Additional equipment

- ZP-1N burner
- insulated tunnel from the back of forge

 Additional tunnel dimensions

140 x 80 x 250 [mm]

 Additional tunel weight

1 [kg]

Customers who bought this product also bought:

other products in the same category:

  • A two -burner forge for medium and large blacksmith workshops. Ideal for heating a large amount of charge, especially in mass production...

  • A one-burner forge perfect for these blacksmiths who want to use it outside the workshop, especially for shoeing horses...

  • A one-burner forge indispensable for medium blacksmith workshops.The gas consumption amounts only 1 kg per hour at a constant operating temperature of 1250 ºC...

  • A one-burner forge perfect for medium blacksmith workshops. Economical and lightweight, with gas consumption of 1 kg per hour ...

  • A small, one-burner forge which may by used mainly for heating smaller workpiece...

  • A four-burner forge for medium and large blacksmith workshops. Ideal for heating up a large amount of charge, particulary in mass production...